High Precision
Positioning Stacking Machine for MLCC - Rx09220Sx (Single type)
Alphasystem Corporation
The equipment
cuts ceramic sheet into a piece of sheet, 220x220mm in size, and
peels off the cut ceramic sheet from the PET film. The peeled ceramic sheet is
stacked by the high precision positioning system.
|
Technical data, stacking machine: |
|
|
Ceramic sheet Size |
+/-0,005 mm |
|
Ceramic thickness |
20 KN 4 KN |
|
PET film width |
max 260 mm |
|
PET film thickness |
30 or 50μm |
|
Height of stacked ceramic pad |
Max 5 mm |
|
Laminating Press |
Max25 ton (Max1min) |
|
Cycle time |
Max 4.7 sec (target time) |
|
Stacking accuracy |
R30μm (target) |
|
Shift amount |
Max 7 mm |
|
Mechanical accuracy |
Max 1μm |
|
Winding and unwinding diameter |
φ500 mm |
|
Primary source power |
AC200V 3-phases 50/60Hz 15KVA 100A |
|
Primary Air pressure supply |
5kgf/ cｍ2 |
|
Dimension |
Single;L1940 x W1700 x H1750 (Bed size: L1940 x W1700) |
Modules of the stacking and lamination machine:
- X-Y Theta positioning unit
- X-Y axis positioning unit (AC servo motor, correction table unit, sensor)
- Vacuum unit (vacuum pump, solenoid valve, sensor)
- Press unit
- Hydraulic unit (AC servo motor, hydraulic pump, oil tank, sensor)
- Cylinder unit (hydraulic cylinder, sensor)
- Press table (press table, parallel unit, air cylinder, sensor)
- Vacuum die unit (vacuum pump, solenoid valve, vacuum die, sensor)
- Positioning CCD camera unit
- BaPeeling and cutting unit for printed sheet & cover sheet
- Tension unit for printed sheet & cover sheet
- Winding and unwinding unit for printed sheet & cover sheet
- Fixing Plate case & Plate set unit
- Frame unit (base frame, frame
- Control box (breaker, relay, PLC, AC servo driver, amplifier)
- Control panel for printed sheet & cover sheet (touch panel, SW)
- HEPA filter unit for printed sheet side
※- Optional hydraulic cooler unit