Tolerances

      1.Thickness: The thickness tolerance is +/-0.001"

      2.Thicknedd in the weld area: The weld area tolerance

         is +0"/-0.002"

      3.Flatness within the belt excluding the weld area:

        The ratio between height and length will not exceed

        1/250 under a 1425 psi pre-tension. Maximum height of

        un-flat area is 0.1"

      4.Width:The width is within +/-0.08"

      5.Surface:The surface will have a Ra value of 0.30

         micrometers.

         The weld to be blended as close as possible to the parent 

          material.